From Ironwood and Copper Ridge out past Shiloh Road, we build custom-framed indoor cedar sauna rooms, low-EMF infrared suites, and modern backyard cube saunas that fit right into your home's layout.
Tell us what you're looking to build on the West End and we'll get you a straight-up estimate.
Whether you're in a newer build out in Copper Ridge, tucked against the Rimrocks in Ironwood, or remodeling a basement off Rimrock Road, a cheap mail-order box sauna sticks out like a sore thumb. We build custom saunas that look like they were framed with the house—matching your trim lines, HOA exterior rules, and floorplan.
Most of our West End work centers on custom indoor hot rooms built right into primary bathrooms, basement home gyms, and spare storage rooms. We frame the stud walls, pack them with Rockwool mineral insulation, tape a heavy-gauge aluminum foil vapor barrier across every stud, and blind-nail Clear Western Red Cedar tongue-and-groove paneling so you never see an exposed fastener. Frameless tempered glass doors, recessed under-bench warm LEDs, and hidden passive intake/exhaust vents come standard.
We also build a lot of custom low-EMF full-spectrum infrared suites and modern outdoor cube saunas on West End patios. If you want a daily 135°F recovery sweat after a workout without waiting 45 minutes for rocks to heat up, our shielded carbon-ceramic infrared panels warm up in 10 minutes and keep EMF levels under 2mG.
We work alongside your general contractor, tile setter, or electrician to frame custom cedar sauna rooms cleanly into master suite and basement remodels.
Double-shielded carbon-ceramic emitters wired in grounded conduit keep EMF readings under 2mG right at the backrest while giving you even, head-to-toe warmth.
Kiln-dried Grade-A Western Red Cedar benches and walls that stay comfortable against bare skin at 195°F, smell great, and never warp or pitch sap.
We serve the entire West End and surrounding high-end communities in Yellowstone County. Click to view dedicated local designs:
Straight answers on 240V electrical circuits, bathroom remodels, and build timelines.
For traditional electric rock heaters (6.0kW to 9.0kW), we run a dedicated 220V–240V, 30-amp to 40-amp circuit from your main panel using heat-rated wire. We coordinate directly with licensed local electricians so all rough-in wiring and digital wall controls sit flush and hidden inside the wall framing.
Yes, we do that all the time in West End primary bath remodels. We set tempered glass panels in anodized channels and seal the shared wall with Rockwool insulation and taped aluminum foil vapor barrier so the wet shower moisture and the 195°F dry sauna room stay completely separated.
Once your cedar package is milled, an indoor custom room takes about 2 to 4 days of on-site carpentry—framing, insulating, foil-sealing, paneling, and building the benches. Outdoor insulated cube and cabin saunas take roughly 3 to 5 days including the pad, roof, and exterior siding.
Give us a call or send a note. We'll come measure your bathroom, basement, or patio and give you a straight-up local quote.